Steps to setup canon printer mx922



  • Steps To Set Up Wireless Connection on Your Canon PIXMA MX922

    Well, settings up the wireless connection to your printer are quite easy so now we will begin with the procedures to set up the printer which is as follows-

    The first is to switch on the printer and press and hold the wifi button till you observe the light starts blinking make sure there is the blue light that will blink.

    Now once through with the above steps now you need to press the WPS button on your access point within two minutes. Now the blue light will start to flash to while looking for the access point.

    The next step is after you done with the above step you will notice that once it connects to the access point and the power the wifi will flash.

    If the process is successful then both the power and wifi lamp will stop to blink now.

    Now you need to check if the above step is successful or not you need to try to run the print test on your network settings of the printer.

    Insert the sheet of paper in the tray for the next procedure of https://www.setupcanonprinter.com/blog/setup-canon-pixma-mx922-printer/.

    Now you need to long-press and maintain the cancel button till the indicator lamp flashes and then release it.

    Well, now your printer will print the network information page which means that the installation of the printer is complete.


Log in to reply
 

Looks like your connection to NodeBB was lost, please wait while we try to reconnect.